To do so, the elevators will travel to the center part of the bridge and then descend to the valley ground via the large opening on the bottom of bridge connecting to the interior elevator tunnel. This gives the overall pathway of elevators.
Apart from this, custom texture chosen from the 36 textures I created before in the previous post is applied on the elevator surfaces to express the sense of motion of the elevators.
Elevators for the Dean of Architecture
Side view
Iso view
Top view
Elevator below eye level tilted at an angle
Front view
Elevators for the Students of Architecture
Side view
Iso view
Top view
Elevator below eye level tilted at an angle
Front view
Comparison of these two elevators
Side view
Elevator for students (left) is larger then that for Dean (right).
Besides, the one for Dean is colored in orange for recognition.
Top view
Elevator for students (left) is in kite shape whereas that for Dean (right) is in V-shape.
Top view
The shape of these two elevators are just fit to each other and there is a cushion at the front of each elevator, so that this can avoid collision in case of accidents when travelling along the same tunnel within the bridge.
Elevators for Dean and Students in 3D Warehouse
No comments:
Post a Comment